Pressing Instructions
Get the best results from your Supacolour heat transfers. Each product has specific pressing requirements — find yours below.
Blocker Pressing Instructions
- Press Temp:140°C - 150°C
- Press Time:10 - 15 Seconds
- Pressure:40psi / Firm
- Manual press use high setting
Fluro Blocker Pressing Instructions
- Press Temp:140°C - 150°C
- Press Time:10 - 15 Seconds
- Pressure:40psi / Firm
- Manual press use high setting
Fluro Pressing Instructions
- Press Temp:140°C - 160°C
- Press Time:10 - 15 Seconds
- Pressure:40psi / Firm
- Manual Press use High Setting
Headwear Pressing Instructions
- Press Temp:140°C - 150°C
- Press Time:10 - 15 Seconds
- Pressure:40psi / Firm
- Manual press use high setting
How to Apply
- 1.Prep your surface — Wipe clean with soap and water, or a 50/50 mix of rubbing alcohol and water. The cleaner the surface, the longer it'll last.
- 2.Pre-press — Place your sticker face down. Using the applicator provided, press firmly back and forth 2–4 times across the whole design. Pay extra attention to thin lines and small text.
- 3.Peel — Gently peel the two sheets apart, watching to make sure the full design lifts onto the carrier sheet. Go slow on fine details. If anything doesn't lift, re-press with the applicator and try from a different angle.
- 4.Place and press — Position your design on the surface. Press firmly with the applicator 2–4 times, then peel the carrier sheet back slowly, checking everything has adhered.
Industrial Wash Blocker Pressing Instructions
- Press Temp:165°C - 175°C
- Press Time:10 Seconds
- Pressure:40psi / Firm
Industrial Wash Pressing Instructions
- Press Temp:165°C - 175°C
- Press Time:10 Seconds
- Pressure:40psi / Firm
Lo Melt Blocker Press Instructions
- Press Temp:130°C - 150°C
- Press Time:12 - 15 Seconds
- Pressure:30-40psi / Med - Firm
- Manual press use higher setting
Lo Melt Pressing Instructions
- Press Temp:130°C - 150°C
- Press Time:12 - 15 Seconds
- Pressure:30-40psi / Med - Firm
- Manual press use higher setting
Promotional Transfer Pressing Instructions
- Press Temp:130°C - 160°C
- Press Time:10 Seconds
- Pressure:40psi / Firm
Soft Shell Blocker Press Instructions
- Press Temp:140°C - 150°C
- Press Time:10 - 15 Seconds
- Pressure:40psi / Firm
- Manual press use high setting
SupaDTF Pressing Instructions
- Press Temp:140°C - 160°C
- Press Time:12-15 Seconds
- Pressure:40psi / Firm
- Manual press use high setting
SupaReflective Pressing Instructions
- Press Temp:150°C - 160°C
- Press Time:12-15 Seconds
- Pressure:2.75 bar / Firm
- COLD PEEL ONLY
Wearable Pressing Instructions
- Press Temp:140°C - 160°C
- Press Time:10 - 15 Seconds
- Pressure:40psi / Firm
- Manual Press use High Setting